My Community

General Upholstery Questions and Comments => General Discussion => Topic started by: baileyuph on February 18, 2018, 09:26:35 PM

Title: Rich - dental chair tech status(?)
Post by: baileyuph on February 18, 2018, 09:26:35 PM
Rich,
How is your chair business going?  Real good I bet!
I did a dental office of about 10 chairs recently.  The chairs were made in China and not near the
old fashion chairs like when you started.

Are there many doing it the way you do?  Like, you install on site (the upholstery that is)still?

I picked up the components and did the work in shop and then installed on site.

I couldn't believe how cheaply the chair construction was.  I didn't think the forms/padding would
last long.  But, of course I have been use to equipment made probably over 30 years ago.

What is the geographical area you serve?  Mostly in your area and nearby coastal?

I suppose the basic walking foot with a flat fell seaming foot serves most of your needs.  Doubt
a serger capability is needed?


Take care,

Always enjoy your post,

Doyle